Maintenance

Gambit+htag2 Programmer Gambit+Hitag2 V3.1 Programmer is intended for RFID ( transponders ) programming.it is mainly produced for programming RFID transponders and generating RFID transponders from the immobilizer dump/eeprom of the car, in...

Motorola MC68HC(7)11 EEPROM programming tool • In circuit / on board EEPROM programming. • Communication with PC via a serial port • CONFIG Register Programming • Pin tester in both operation modes Package includes: Main hardware...

ProgramTool-48PXP Processor Features For ProgramTool-48PXP Intelligent Universal Programmer USB or parallel port interface with auto-switch power Support 5V and 3.3V low voltage devices, 1.8V chip support through low voltage adapter. Less...

ProgramTool-848XP TurboGang Processor Features 8 independent fully isolated 48-pin ZIF sockets Support Flash, EPROM, EEPROM, Microprocessor with 5 Volts and 3 Volts Program 8 pieces 8 MB Flash chips within 45 seconds Auto-sense, self-start...

Super-Program OBD-3000U Features: CE and FCC approved. Programs high-density Flash memory devices at near theoretical minimum programming times (Program+verify INTEL28F320W18, 32Mb less than 13.5s ) Standard 48 pin universal pin-drivers...

Super-Program OBD-9000U Advanced Stand-Alone Universal Gang Programmer Features: CE and FCC approved. Four independent programming modules in one unit. Even the algorithm engines are independent to each others. Besides the traditional...

X-programmer The XPROG supports programming of Motorola 68HC05xx, 68HC08xx, 68HC11xx microcontrollers internal EEPROM and serial EEPROM's - most used programmable device in car radios, automotive computers (dashboards, AIRBAG, immobilizers), and...